Standard Features:
- Full moldboard trip with four (4) extension type springs
- 10'/11'/12' standard plow lengths
- 38"/43"/46"/48"/52" plow heights (measured with 6" cutting blade)
- 10 ga. moldboard
- Eight (8) 1/2" ribs, fully welded
- Two (2) heavy duty 4"x 19" reversing cylinders with 2" nitrated rods
- Cylinders are mounted above the push frame
- Replaceable Brass Bushing at Dead End of Cylinders for Extended Wear
- Push frame is 88" wide with four (4) main hinge points (see options)
- Push frame is constructed with 3/8"x 4"x 4" square tubing
- 3/4"x 4"x 4" lower angle
- Adjustable attack angles - 10 & 20 degrees
- 5/8"x 8" cutting edge with standard A.A.S.H.O. punch
- Plow lifts level and reverses level
- Various hitches available, plow and truck portions
Options:
- Also available with trip cutting edge & combination trip cutting edge/moldboard trip
- Longer plow lengths available upon request
- Heavy Duty Push frame (HDP) is 117" wide and constructed with 3/8"x 4"x 4" square tubing, Ten (10) 1/2" ribs (in lieu of eight) fully welded, Six (6) main hinge points (in lieu of four) with the furthest hinge point extending about 13" from the end of the plow
- Adjustable mushroom shoe pads, standard or Ni-hard or flat shoe pads
- Plow markers – plastic or cable
- Rubber snow deflector
- DXV Cushion Valve to protect Reversing Cylinders
- Available in UTAW Model (Warped Board) height is 46". Moldboard has larger curl/belly and a more relaxed cutting edge angle (approx. 26 degrees). This design will throw snow better and is more suitable for gravel and seal coated roads.
Literature
